I have two routers at a site. Each are running EIGRP within the same AS. (Router A and Router B). How do I implement load balancing over each routers serial interface so that 50% of the traffic is handled by each interface. PLEASE NOTE: This is not one router with two serial interfaces, but two separate routers. Would HSRP help in anyway??
Router A (serial interface IP 10.5.5.1) EIGRP (AS 100)
Router B (serial interface IP 10.5.5.2) EIGRP (AS 100)
You will need to configure your network such that both routers knows the route to the remote via the their serial interfaces and also via each other, set vhe variance to accommodate the routes from the other router. The router should load balance then
I think olorunloba's way is on the mark. You could also use MHSRP, but this requires you to configure some devices behind the routers with with one gateway (router A's VIP) and others with a second gateway (router B's VIP).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.