cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
205
Views
0
Helpful
1
Replies

EIGRP on IPSEC on serial interface

anu-s
Level 1
Level 1

I have router1 connected to router 2 through service provider , in both the routers loopback ip address have been provided from the servive provider, the link between the two routers are not connected directly , i.e it goes through a service provider.

IPSEC comes up when ever intresting traffic goes out of the serial interface , now i need to run eigrp routing protocol between the routers , since i dont have gre tunnel , pls suggest how do i run eigrp between the two routers.

Anybody who can help me out on this.

1 Reply 1

bbaley
Level 3
Level 3

Check the tech tips page, a ton of information on EIGRP is there.

http://www.cisco.com/warp/public/103/index.shtml

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: