I have router1 connected to router 2 through service provider , in both the routers loopback ip address have been provided from the servive provider, the link between the two routers are not connected directly , i.e it goes through a service provider.
IPSEC comes up when ever intresting traffic goes out of the serial interface , now i need to run eigrp routing protocol between the routers , since i dont have gre tunnel , pls suggest how do i run eigrp between the two routers.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.