By default the IP stack for Netware 3.x listens for RIP. You can disable this feature and configure a default gateway but you will have to edit the 'startup.ncf' file. Have a look on Novell's website for the exact syntax - its been years since I touched it, but I specifically remember this issue.
Try this page on Novell's site - since you have netware 3.12 it may not have all the info you need:
There looks like that there is routing problem. You need to enable ipx routing on the local routers in the remote branches. Have RIP and EIGRP running on the routers. And disable rip advertisement on the specific ipx network. By default redistribution is enabled between rip and eigrp.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...