Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

EIGRP Redistribute

Hi

I want to redistribute the connected interfaces in eigrp .The router has 2 gigabit,2 fast ethernet and 8 serial interfaces.How can I redistribute this interfaces that have different bandwidth??

Regards Ilir

Thankyou

4 REPLIES
Purple

Re: EIGRP Redistribute

Hi,

There are 2 options:

- configure network statements under the EIGRP process that include the IP addresses configured on these interfaces

- use 'redistributed connected' to include these networks in EIGRP. Ensure that you configure a metric value when doing so or the networks will not be included.

Hope that helps - pls do remember to rate posts that help.

Paresh

New Member

Re: EIGRP Redistribute

Ok

I want to use "redistribute connected"

but I don't know the value of K1 metric value

Purple

Re: EIGRP Redistribute

Hi,

In the case of connected routes, the specific of the metric values is not required. Even if you do specify a 'default-metric' it will be ignored and the metric values will be copied over from the actual interface parameters i.e. the actual bandwidth and delay values for the interfaces will be used in calculating the metrics.

Hope that helps - pls do remember to rate posts that help.

Paresh

New Member

Re: EIGRP Redistribute

Thankyou

Regards Ilir

143
Views
4
Helpful
4
Replies
CreatePlease to create content