Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

EIGRP will not fail over

Can anyone help please. I have a 2611 and simply want the router to fail over to the backup DSL link when the primary fails. The problem is the primary is connected to a media converter which then connects to a point to point wireless access point. When the wireless goes down the media converter is still active so the router thinks the link is still alive and doesnt fail over. I have tried object tracking of the routing state will no luck, the only way i can get it to fail over is to physically pull out the RJ45.

3 REPLIES

Re: EIGRP will not fail over

Are you referring the object tracking of routing state to the dialer watch?

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1828/products_configuration_guide_chapter09186a00800872ed.html

Rgds,

AK

Silver

Re: EIGRP will not fail over

Or if you use dynamic routing protocol and floating static to maintain the fallover. Once the route disappear, static will appear in routing table then use backup path.

Hope this helps.

134
Views
0
Helpful
3
Replies
CreatePlease to create content