Yes, you may switch to EIGRP if all your network is Cisco based.
EIGRP is supported by IOS versions 9.something and later. However, you will not be able to utilize some of the newer enhancements to EIGRP, like, MD5 Authentication, which is supported only by IOS 11.3 and beyond.
RIPv1 is defnitely NOT compatible with EIGRP. From your requirements, I would recommend that you configure things one at a time. That is keep RIPv1 and IPX routing enable as usual then start to configure EIGRP routing for IP first. By default EIGRP will be more prefered than RIPv1 so once you've configured EIGRP everywhere on your network, you'll find that all your routes will be preferred by EIGRP. Then slowly take RIPv1 off and see if things still work or not (REALLY slowly here, ie one by one). Once IP routing is working properly, then move on to integrate IPX routing using EIGRP and follow the same slow process as IP. Note that IPX routing inside EIGRP is an add on option.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.