When advertising eigrp routes out of an interface, if im joining my interfaces onm a 192.168.10.0 network for example, do i need to advertise this in eigrp even though there would be only 2 addresses ?
If you have to advertise the link between A and B to advertise the networks behind A to C from B? If so, you don't have to. You can filter out the A to B network at B, towards C, and everything will still work fine. If you're asking if you have to include the A to B link in the EIGRP process on A and B, then the answer is yes, you must, for A and B to form a neighbor adjacency across the link.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...