Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

eigrp

Is it possible for me to adjust my eigrp timer updates between 2 sites so that it doesnt keep bring up my isdn line ?

2 REPLIES
Bronze

Re: eigrp

Hi Carl

To my best knowledge, I think the soultion would involve something like this

router eigrp 64

passive-interface Serial0

network 10.1.1.0 0.0.63.255

network 172.17.5.0 0.0.0.255

no auto-summary

The passive-interface command on the right interface (which in your case would be bri0 or s0) should do the trick)

Im just a newbie though .. would like a second opinion on this :)

Silver

Re: eigrp

I would also agree. Putting the Bri0 interface as a passive interface would keep the line from coming up from routing updates from exiting the interface.Using passive interfaces in EIGRP will suppress incoming and outgoing routing updates on that interface, along with Hello messages. The bad thing about this is you will lose your neighbor relationship with the connected router on the bri0 interface.

Since they are connected, you should still have a route pointing to the connected router out of the bri0 port. If not you can use a static ip route.

This link my be helpful.

http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080093f0a.shtml

Hope this helps and please rate!

Scott

106
Views
0
Helpful
2
Replies
CreatePlease to create content