Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

enable portfast on all ports of 2950.

Sorry I corrected my question.

Can I enable portfast on all ports of a Catalyst 2950

by one command:

Config#spanning-tree portfast default

or I can only enable portfast on a per port basis.

thanks

4 REPLIES
VIP Purple

Re: enable portfast on all ports of 2950.

Hello,

you can either use the global command 'spanning-tree portfast default', which will put all ports in portfast mode, or the interface command 'spanning-tree portfast' to enable portfast on a specific port.

Further, you can also use the 'interface range' command to configure portfast on a range of interfaces, e.g.:

interface range FastEthernet0/1 - 24

HTH,

GP

New Member

Re: enable portfast on all ports of 2950.

Hi GP thanks for your help.

For the interface range command.

Should I do it in Config# mode

or should I do it in Config-if# mode

Thanks

New Member

Re: enable portfast on all ports of 2950.

Hi,

Whatever, both are correct.

MB

New Member

Re: enable portfast on all ports of 2950.

Thanks...

2322
Views
0
Helpful
4
Replies