07-05-2006 10:38 AM - edited 03-03-2019 03:55 AM
Reading the doc, it indicates that it supports virtual console. But how can we enable it? Thanks
07-05-2006 01:38 PM
It should be enabled, however, if it's not enabled please do the following:
- config command
Router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#red
Router(config-red)#main
Router(config-r-mc)#standby console enable
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_2_31s/conf/rpr.htm#wp1143094
Please rate all posts.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: