Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Enabling Caller Id

I was reading about how I could enable caller ID recept on My 3660 router.

My users connect via NM16 modules thorugh POTS. the POTS service provider has enabled this feature on those lines.

Must I have a voice module or other modules to recieve the number on the router.

Is there a comman for this to happen.

1 REPLY
Bronze

Re: Enabling Caller Id

Caller ID feature supported on only VIC-2FXO-M1 or VIC-2FXO-M2 modules for 3660 router. See the following links for more information on these modules and how to configure the caller id feature...

http://www.cisco.com/warp/public/788/products/2fxo_vic.html

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121newft/121t/121t3/clid_t4.htm

103
Views
0
Helpful
1
Replies
CreatePlease to create content