Hi All,
I am enabling RBE bridging for DSL on a Cisco 7513 router. Here is my sample config that I've drafted for it, for an ATM subinterface. My question is pretty striaghtforward: should this config work? If not, any suggestions, feedback, would be appreciated. Just trying to get another set of eyes on this.
!
interface ATM10/0/0
no ip address
no ip directed-broadcast
no ip route-cache distributed
logging event subif-link-status
atm uni-version 3.1
no atm auto-configuration
no atm ilmi-keepalive
no atm address-registration
no atm ilmi-enable
atm arp-server self
!
interface ATM10/0/0.1 point-to-point
description DSL Network utilizing RBE
ip unnumbered Loopback1
no ip directed-broadcast
no ip route-cache
ATM route-bridged ip
atm pvc 1 1 32 aal5snap 5500 4700 100
bridge-group 1
!
Thanks.