Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Enabling RBE Bridging for DSL

Hi All,

I am enabling RBE bridging for DSL on a Cisco 7513 router. Here is my sample config that I've drafted for it, for an ATM subinterface. My question is pretty striaghtforward: should this config work? If not, any suggestions, feedback, would be appreciated. Just trying to get another set of eyes on this.

!

interface ATM10/0/0

no ip address

no ip directed-broadcast

no ip route-cache distributed

logging event subif-link-status

atm uni-version 3.1

no atm auto-configuration

no atm ilmi-keepalive

no atm address-registration

no atm ilmi-enable

atm arp-server self

!

interface ATM10/0/0.1 point-to-point

description DSL Network utilizing RBE

ip unnumbered Loopback1

no ip directed-broadcast

no ip route-cache

ATM route-bridged ip

atm pvc 1 1 32 aal5snap 5500 4700 100

bridge-group 1

!

Thanks.

1 REPLY
Cisco Employee

Re: Enabling RBE Bridging for DSL

The config may not work,

You want to configure 7513 to terminate the DSL connection running RBE..Means 7513 will work as DSL aggregator for RBE connection, here is the sample config for that

http://www.cisco.com/warp/public/794/soho77rfc_6400rbe_1.html

Config is for 6400 but will be the same for 7513 too.

You need to enter a static route for a user's ip address (10.1.1.1 in sample config) if ip address are not allocated via dhcp server.

163
Views
0
Helpful
1
Replies
CreatePlease to create content