Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Enabling UDP broadcast

How can udp packets can be enabled on a CMTS so that stock datas can be forwarded over a cable network, which can be used by end customers spanning a wide area with their cable modems.

1 REPLY

Re: Enabling UDP broadcast

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

106
Views
0
Helpful
1
Replies
CreatePlease to create content