Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

encapsulation dot1q on a 2500

I have a 2503 and have went through four different versions of IOS (currently on 12.2(32)) trying to find one that would allow me to do encapsulation dot1q on a sub-interface. Is this possible on a 2500?

Thanks,

Jesse

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: encapsulation dot1q on a 2500

2503 does not support inter-vlan routing because it's ethernet interfaces work on 10 mbps.however inter-vlan routing should be set on min 100mbps.

5 REPLIES

Re: encapsulation dot1q on a 2500

Jesse,

Cisco Feature Navigator doesn't show 802.1q as being supported on 2500 series routers. Use this tool for software research and selection. Here's the link for it.

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

HTH

Sundar

New Member

Re: encapsulation dot1q on a 2500

Is configuring InterVLAN routing possible on a 2500?

Jesse

Purple

Re: encapsulation dot1q on a 2500

Probably not that is a real old router . Does it even have a fast ethernet interface ? If not then you cannot trunk ....

New Member

Re: encapsulation dot1q on a 2500

2503 does not support inter-vlan routing because it's ethernet interfaces work on 10 mbps.however inter-vlan routing should be set on min 100mbps.

New Member

Re: encapsulation dot1q on a 2500

That is what I was looking for. I guess my home lab needs are not falling in line with my bank account realities. :-)

Thanks,

Jesse

868
Views
0
Helpful
5
Replies