Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

err_disable

Hi all,

This morning we had four ports on our 6500 switch in error disable mode, here are some lines from the log output, there was no errors on that interfaces, could be a hardware problem?

Jun 20 17:04:15: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 1 is experiencing the following

error: Bus Asic #1 transient Pb error. Recovered. (0x0002, 0x0000)

Jun 20 17:04:20: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 1 is experiencing the following

error: Bus Asic #1 transient Pb error. Recovered. (0x0002, 0x0000)

Jun 20 17:04:26: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 1 is experiencing the following

error: Bus Asic #1 transient Pb error. Recovered. (0x0002, 0x0000)

Jun 20 17:04:32: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 1 is experiencing the following

error: Bus Asic #1 transient Pb error. Recovered. (0x0002, 0x0000)

Jun 20 17:04:37: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 1 is experiencing the following

error: Bus Asic #1 transient Pb error. Recovered. (0x0002, 0x0000)

Jun 20 17:04:43: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 1 is experiencing the following

error: Bus Asic #1 transient Pb error. Recovered. (0x0002, 0x0000)

Jun 20 17:04:48: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 1 is experiencing the following

error: Bus Asic #1 transient Pb error. Recovered. (0x0002, 0x0000)

Jun 20 17:04:54: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 1 is experiencing the following

error: Bus Asic #1 transient Pb error. Recovered. (0x0002, 0x0000)

Jun 20 17:04:59: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 1 is experiencing the following

error: Bus Asic #1 transient Pb error. Recovered. (0x0002, 0x0000)

Jun 20 17:05:05: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 1 is experiencing the following

error: PINNACLE Pb transient parity error detected : ports - 1 3 5 7

The last line shows the ports that were in err_disable status, after shut and no shut all appear to be working fine...

Any idea about it?

Thanks a lot in advance,

1 REPLY
New Member

Re: err_disable

692
Views
0
Helpful
1
Replies
CreatePlease to create content