Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

errdisable detect loopback on trunks

Hi,

on interfaces configured as trunk, like

interface GigabitEthernet 1/0/1

switchport trunk encapsulation dot1q

switchport trunk native vlan 11

switchport mode trunk

!

and 'errdisable' detect and recovery configured for all causes with a timeout of 300 seconds a looped link is not detected. This is not the behavior I expected. Am I missing something?

I'm using Cat 3750 with 12.2(25).SED1.

If someone could help me, this would be fine.

thanks in advance and kind regards

Mark

1 REPLY
Silver

Re: errdisable detect loopback on trunks

check out the following command reference for enabling errdisable :

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_command_reference_chapter09186a008017f9b3.html#2233305

hope this helps.

125
Views
0
Helpful
1
Replies
CreatePlease login to create content