Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

errdisable on a Cat-6506 & CW2K

We have a switched network, where a couple of Cat-6506's constitute the backbone. We're monitoring this network with LMS 2.1, where we utilize the e-mail notification for any major network problems. This morning, one of the ports on a Cat-6506 went into the errdisable mode and, as a result, brought down the server that was attached to it. The error was captured on the syslog but not on the DFM, so we did not get any notification. Is there any way to configure DFM for this specific error message?

Thanks.

_ Alex

1 REPLY
Silver

Re: errdisable on a Cat-6506 & CW2K

This document should help you in doing that .

How To Enable Device Fault Manager Mail Notifier

http://www/en/US/products/sw/cscowork/ps2421/products_tech_note09186a00800c460f.shtml

86
Views
0
Helpful
1
Replies