Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Erroneus configuration register

Hello, I have introduced an erroneous configuration register (0x022) and reset in a Cisco 827 DSL router, and now I cannot enter in rmon or something

¿What can I do?

3 REPLIES
New Member

Re: Erroneus configuration register

What output are you receiving on the screen when you power the router on? Also, are you certain that your configuration register is set to 0x022?

New Member

Re: Erroneus configuration register

Yes, I'm sure, I only receive trash like this

---> ????ooooo

New Member

Re: Erroneus configuration register

Try changing the baud rate settings in your terminal program. Its possible that it was accidentally changed to something other than 9600. Once you change the setting, reconnect and hit enter a couple of times. If you still get garbage on the screen, disconnect, change them again. Keep trying until you either run out of settings (there's only like 10 - 12 of them), or it works.

Good luck!

88
Views
0
Helpful
3
Replies