Erroneus configuration register

[darro]

Hello, I have introduced an erroneous configuration register (0x022) and reset in a Cisco 827 DSL router, and now I cannot enter in rmon or something

¿What can I do?

[mbruner]

What output are you receiving on the screen when you power the router on? Also, are you certain that your configuration register is set to 0x022?

[darro]

Yes, I'm sure, I only receive trash like this

---> ????ooooo

[mbruner]

Try changing the baud rate settings in your terminal program. Its possible that it was accidentally changed to something other than 9600. Once you change the setting, reconnect and hit enter a couple of times. If you still get garbage on the screen, disconnect, change them again. Keep trying until you either run out of settings (there's only like 10 - 12 of them), or it works.

Good luck!