Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

error message

Hi,

has anyone seen the following error message?

"%ISDN-6-LAYER2UP: Layer 2 for Interface BR2/0, TEI 64 changed to upEORROR - Total length is not equivalent to sum o

f field lengths."

Interface BRI 2/0 is a voice BRI

Or:

"%LINK-5-CHANGED: Interface Dialer1, changed state to standby modeEORROR - Total length is not equivalent to sum of

field lengths"

Dialer 1 is linked to a data BRI, which is used for backup.

I had this message in many branch 3662 routers at the same day, for a reason I cannot think of...

Yanna

1 REPLY

Re: error message

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

112
Views
0
Helpful
1
Replies
CreatePlease to create content