Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

error on 6509

GOOD DAY!

Could some body;tell me what is this error in my 6509?

Have a look to this error?

00:16:53: %C6KERRDETECT-SP-2-LPBKFAIL: The in-band loopback test between switch

processor and route processor failed, count:40

00:16:53: SP: SP-RP Ping Test[1]: CPU util(5secs): SP=0% RP=0%, Traffic=0%

00:16:53: SP: SP-RP Ping Test[1]: netint_thr_active[0], Tx_Rate[413], Rx_Rate[0]

, bus_stall[0]

10xs for help

Ali

5 REPLIES

Re: error on 6509

Hi Alsayed,

Explanation: The C6KERRDETECT-SP-2-LPBKFAIL message is displayed when the in-band loopback test between switch processor and route processor fails. In other words, the system detects an error that cannot be recovered during the in-band loopback test.

Recommended Action: Check the Cisco CatOS image for checksum errors. If thereare no checksum errors, replace the supervisor module. Issue the show test {module_number} command before and after you physically re-seat the module to make sure that theline card is not faulty. Ensure that you have configured the set test diaglevel complete command. A reset is required to enable this diagnostic mode. If the problem persists, there can be a faulty hardware that needs replacement. Open a service request with Cisco through TAC Service Request Tool.

hope this helps,

rate this post.

New Member

Re: error on 6509

HI Freind!

10xs for ur response.i dont Have CATos on this box.i have converted the from catos to IOS 3 Days ago.

10xs.any new help

Ali

Re: error on 6509

but atleast did u check for any CRC err. & also tried removing the module etc..?

New Member

Re: error on 6509

Hi Friend!

how can i check the CRC;BUT When i removed the module.every thing fine.

10xs

New Member

Re: error on 6509

can you give us a show mod? if you do a verify on the code on the flash you will check the CRC (you will have to be in enable mode to do a verify), so if the code verify's o.k. you will probably want to open a TAC ticket in that the module is bad.

202
Views
7
Helpful
5
Replies
CreatePlease login to create content