Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

nss
New Member

Error when setting CIR in FR-map-class

I am currently configuring a 7206 for Frame-Relay, and have encountered an error when trying to set the CIR in a map-class.

The map-class looks like:

!

map-class frame-relay FR64

frame-relay cir 64000

!

The problem is that when I try to set the CIR to 65536 (64*1024) I get the following error:

Cisco7206A(config-map-clas)#frame cir 65536

Map Class Error: Numbers >= 2048 need trailing 0's,

43 65536 0 65536

Cisco7206A(config-map-clas)#

Has anyone come across this before?

We have another 7206 configured for FR and we have no problems setting CIR=65536.....

1 REPLY

Re: Error when setting CIR in FR-map-class

Often times complex troubleshooting issues are best addressed in an interactive troubleshooting session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

85
Views
0
Helpful
1
Replies