Errors accessing slot0:

tkresnicka · ‎07-23-2002

I'm trying to access sup-slot0: from either msfc on a 6509. Sups are 1As and msfcs are 1s. The 6509 is running hybred mode with Cat 6.3.5 on sups. I'm trying to copy IOS from slot0: to msfc bootflash and an receiving timeouts -

ho-ntc-rsw4> (enable) copy tftp:c6msfc-jsv-mz.121-8b.E11.bin slot0:

IP address or name of remote host [10.xxx.xxx.xxx]?

24772480 bytes available on device slot0, proceed (y/n) [n]? y

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

File has been copied successfully.

ho-ntc-rsw4> (enable) sess 16

Trying Router-16...

Connected to Router-16.

Escape character is '^]'.

ho-ntc-rsw4-msfc1(boot)#$ot0:c6msfc-jsv-mz.121-8b.E11.bin bootflash:

Destination filename [c6msfc-jsv-mz.121-8b.E11.bin]?

Accessing sup-slot0:c6msfc-jsv-mz.121-8b.E11.bin...

Loading slot0:c6msfc-jsv-mz.121-8b.E11.bin ...from 127.0.0.11 (via EOBC0/6): !

Loading slot0:c6msfc-jsv-mz.121-8b.E11.bin

%Error opening sup-slot0:c6msfc-jsv-mz.121-8b.E11.bin (Timed out)

ho-ntc-rsw4-msfc1(boot)#

I've reformated pcmcia(s) and re-tftped IOS to same pcmcia(s) with same result, msfcs can't access slot0. Any ideas?

Prashanth Krishnappa · ‎07-23-2002

Look at the following bug

http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCdt17684

Why dont you use TFTP to download IOS into the MSFC bootflash?

tkresnicka · ‎07-23-2002

I'm trying to run SRM on this switch. I have successfully tftped new IOS to active msfc (15). This msfc is the standby. Trying to follow the book which says to move the new IOS through slot0: Ref:Cat6000 Software Config Guide (22-45), for the standby msfc...