Most of the time CRC errors are result of a Port configured in Auto Speed/Duplex mode and the host connected to this Port (Or another Switch Port)has hard coded speed/Duplex setting, as a result effective communication drop to Half Duplex and results in CRC Errors.
If you are positive its not the issue, then make sure Port Hardware is okay and also cable length is not more than its specs.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...