Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Errors on startup, 2611

Every time I reboot my 2611,I get these errors on start up. How can I get rid of them?

%Error opening tftp://255.255.255.255/network-confg (Timed out)

%Error opening tftp://255.255.255.255/cisconet.cfg (Timed out)

%Error opening tftp://255.255.255.255/artemis-confg (Timed out)

Thanks for any suggestions!

pat

%Error opening tftp://255.255.255.255/artemis.cfg (Timed out)

  • Other Network Infrastructure Subjects
7 REPLIES
New Member

Re: Errors on startup, 2611

Do a show run and check for "boot system tftp ...."

Where does your config exist, flash or tftp server?

see

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/fun_r/frprt2/frd2005.htm#xtocid3285

New Member

Re: Errors on startup, 2611

My configuration is in flash, there no mention of tftp anywhere in my configuration. I have tried deleting them and get this back:

apollo#delete tftp://255.255.255.255/network-confg

Address or name of remote host [255.255.255.255]?

Delete filename [network-confg]?

Delete tftp://255.255.255.255/network-confg? [confirm]y

%Error deleting tftp://255.255.255.255/network-confg (Invalid argument)

Thanks!

Pat

New Member

Re: Errors on startup, 2611

I think Catalyst also 6000 have same you error message,below web link can help u.

http://www.cisco.com/warp/customer/473/81.shtml

New Member

Re: Errors on startup, 2611

go into rommmon mode and type "SET"

you will see a bunch of parameters.

see if you see anything there. Also check to see at the beginning of your config the "Service" line

make sure it is not directed to a file in your flash

Late

New Member

Re: Errors on startup, 2611

Here is all it says in configuration about service:

Current configuration:

!

version 12.0

service config

service timestamps debug uptime

service timestamps log uptime

no service password-encryption

There was nothing weird in rommon. These errors occur on start up and inject themselves again when I type in enable and usually disrupt the typing of the secret. Once in enable mode, they go away until I restart.

New Member

Re: Errors on startup, 2611

dude its right there

Take out "Service config"

router(config)# no service config

:)

New Member

Re: Errors on startup, 2611

make sure your config register = 0x2102 or 0x2101

if config register =0x2102 then make sure the sure your "boot" = boot system flash %system image on flash% [e.g boot system flash c3640-is-mz.121-1.bin]

config register 0x2101 should be fine if you have only one IOS system image file on the flash card

198
Views
0
Helpful
7
Replies
This widget could not be displayed.