Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Errors Pasting Config To Router...Help.

When pasting a complete config using Hyperterminal to a router I'm getting errors because I'm over-running the serial buffer. I know there is a way to slow down the speed at which the config is 'pasted' in to the router (as I've had this problem before). However for the life of me I can't remember the command.

It was something like 'line delay' with a time of so-many milliseconds or something like that.

Can anyone help me out?

TIA

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Errors Pasting Config To Router...Help.

2 REPLIES

Re: Errors Pasting Config To Router...Help.

New Member

Re: Errors Pasting Config To Router...Help.

Thanks Steve,

It had been a long day and I wasn't thinking straight. I set the line delay in Hyperterminal to 500 miliseconds and it resolved the problem.

Cheers,

Dominic.

276
Views
5
Helpful
2
Replies
CreatePlease to create content