10-11-2002 04:55 PM - edited 03-02-2019 02:01 AM
When pasting a complete config using Hyperterminal to a router I'm getting errors because I'm over-running the serial buffer. I know there is a way to slow down the speed at which the config is 'pasted' in to the router (as I've had this problem before). However for the life of me I can't remember the command.
It was something like 'line delay' with a time of so-many milliseconds or something like that.
Can anyone help me out?
TIA
Solved! Go to Solution.
10-12-2002 04:27 AM
See this link: http://www.cisco.com/en/US/products/hw/routers/ps331/products_password_recovery09186a0080094ebc.shtml#transfer
(under file, properties, settings ...)
Steve
10-12-2002 04:27 AM
See this link: http://www.cisco.com/en/US/products/hw/routers/ps331/products_password_recovery09186a0080094ebc.shtml#transfer
(under file, properties, settings ...)
Steve
10-13-2002 07:34 AM
Thanks Steve,
It had been a long day and I wasn't thinking straight. I set the line delay in Hyperterminal to 500 miliseconds and it resolved the problem.
Cheers,
Dominic.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: