Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ESCON Channel Interface Versions

Hello,

I have a board CX-CIP2-ECA1 with a single ESCON chan intf, Interface version 1. Could I add a second ESCON intf CX-ECA1-U= which is version 3 in same

Motherboard CX-CIP2-ECA1. Or are there some restrictions ?

Thanks Ruedi

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: ESCON Channel Interface Versions

I don't think there are any restrictions. All the different versions of the ECA can work with CIP2. But, there are certain restrictions for the IOS releases and microcode releases for the CIP2 if you use different versions of the ECA. This link might help you :

http://www.cisco.com/en/US/products/hw/routers/ps359/prod_module_installation_guide09186a00800e9d03.html#29050

2 REPLIES
Silver

Re: ESCON Channel Interface Versions

I don't think there are any restrictions. All the different versions of the ECA can work with CIP2. But, there are certain restrictions for the IOS releases and microcode releases for the CIP2 if you use different versions of the ECA. This link might help you :

http://www.cisco.com/en/US/products/hw/routers/ps359/prod_module_installation_guide09186a00800e9d03.html#29050

New Member

Re: ESCON Channel Interface Versions

Hello,

Thanks for answer. I installed the two modules and it works.

Ruedi

166
Views
0
Helpful
2
Replies
CreatePlease to create content