Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Ether Channel in 3524

Hi,

I want to configure an ether channel in 3524 with 6509. There are 2 3524 configured in cluster mode. 3524 has two gigabit ports. So I am left with one port from each switch to configure channel(the other port is used for clustering). But when I configure channel with "port-group 1" in both the switches (gig0/2 in each switch), the spanning tree is bringing the ports down. So pls suggest what to do in this scenario?

Thanks and Regards,

Silju

1 REPLY
New Member

Re: Ether Channel in 3524

you can't channel to two devices from a single 6509, if that is what you are trying to do.

119
Views
0
Helpful
1
Replies
CreatePlease to create content