Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ether channel Link failure


I have 2 switches connected with ether channel with a bundle of 4 links

My q is one link in a switch fails or unplug then is there will be abu loop or error ?

I want to know is it will be a problem 

Everyone's tags (1)
Super Bronze

DisclaimerThe Author of this


The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.


No (problem).

New Member

Hello engrmithun,No, it will

Hello engrmithun,

No, it will not cause a problem, if a link within the Etherchannel fails traffic will be shifted to other remaining links, are facing a specific problem ? 


For further information check this document , Understanding EtherChannel Load Balancing and Redundancy on Catalyst Switches.


CreatePlease to create content