Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Etherchannel 2811 with 4501 Catalyst switch

I am trying to set up an Etherchannel between two FastEthernet on 2811 with a Catalyst 4501 switch. The channel is established fine except that I can't get any traffic to go across the etherchannel. Any ideas?

Thanks in advance

1 REPLY
Cisco Employee

Re: Etherchannel 2811 with 4501 Catalyst switch

Only ports on etherswitch module support channeling in a 2811(built in FE interfaces do not)

157
Views
0
Helpful
1
Replies
CreatePlease to create content