Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

Etherchannel between diferent chassis

Is possible to create an etherchannel between 2 GBIC interfaces of a Catalyst 4506 in one side and two GBIC interfaces of two different Catalyst 6000 chassis inthe other side?.

3 REPLIES
Gold

Re: Etherchannel between diferent chassis

should be no problem.

Re: Etherchannel between diferent chassis

Thank you for your reply.

How can I do it? because I believed that the etherchannel only works between 2 switches, but not between one switch on one end amd 2 switches on the other end (in fact, this is the configuration I intend to deploy).

Bronze

Re: Etherchannel between diferent chassis

I don't think you can do that. The Etherchannel must terminate on both ends into a single chassis AFAIK...

98
Views
0
Helpful
3
Replies
CreatePlease to create content