Currently I have a 100mb full duplex link to a Compaq server. I am upgrading the link to 200mb full duplex using EtherChannel. The mode will be set to on.
If I configure an EtherChannel group on the switch prior to setting up EtherChannel on the Compaq server, will the link continue to operate at 100mb full duplex until make the server changes can be made?
Yes it will continue to work at 100 Full Duplex. But the switch ports assigned to the Ehterchannel may start to flap. Some packets may be dropped. I have experienced this yesterday. The best thing to do is enable the Compac Load Balancing and then enable the cisco Etherchannel.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...