Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

etherchannel router with 3548XL Switch

Hi

i have 3640 with FE

and 3548XL Switch

Right now i have connceted one FE port with 3548XL Switch and running fine

due to over load traffic on network

i want to another port of FE from 3640

so iam looking like this

i want to make 200MB Full duplex

and load balance too

and i want to configure only one IP address for the router Ethernet ( for both the interface)

how can i achive this

hari

5 REPLIES
Bronze

Re: etherchannel router with 3548XL Switch

Something like this:

On switch:

conf t

interface fa0/1

port group 1 distribution destination

interface fa0/2

port group 1 distribution destination

exit

On Router:

conf t

interface port-channel 1

ip address x.x.x.x y.y.y.y

interface fa0/0

no ip address

channel-group 1

interface fa0/1

no ip address

channel-group 1

exit

-HTH

New Member

Re: etherchannel router with 3548XL Switch

Hi

thanks for the reply

but i could not able to excute that command in my Rouer

i having following IOS

cis-3640#show ver

Cisco Internetwork Operating System Software

IOS (tm) 3600 Software (C3640-IO3-M), Version 12.2(12), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Wed 21-Aug-02 00:44 by pwade

Image text-base: 0x60008930, data-base: 0x60A50000

ROM: System Bootstrap, Version 11.1(20)AA2, EARLY DEPLOYMENT RELEASE SOFTWARE (f

c1)

cis-3640 uptime is 3 minutes

System returned to ROM by power-on

System image file is "flash:c3640-io3-mz.122-12"

cisco 3640 (R4700) processor (revision 0x00) with 60416K/5120K bytes of memory.

Processor board ID 21475150

R4700 CPU at 100Mhz, Implementation 33, Rev 1.0

Bridging software.

X.25 software, Version 3.0.0.

2 FastEthernet/IEEE 802.3 interface(s)

2 Serial network interface(s)

DRAM configuration is 64 bits wide with parity disabled.

125K bytes of non-volatile configuration memory.

12288K bytes of processor board System flash (Read/Write)

cis-3640(config)#interface port-channel 1

^

% Invalid input detected at '^' marker.

cis-3640(config)#

can you recomend me what IOS i should use

hari

when i

Bronze

Re: etherchannel router with 3548XL Switch

Sorry. Fast etherchannel isn't supported on 3600 routers AFAIK.

You might need to set up a separate IP subnet on a new FastE interface.

-HTH

New Member

Re: etherchannel router with 3548XL Switch

what routers support this etherchannel

then i can not use this router for the same option

hari

Bronze

Re: etherchannel router with 3548XL Switch

7xxx routers do. Also many of the newer switches support layer 3 etherchannel including the 6500 and 3550 series.

-HTH

118
Views
0
Helpful
5
Replies
CreatePlease login to create content