Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

reo
New Member

EtherChannel

I have 3 Catalyst 3524 switches. In first GBIC slots there are GigaStack GBICs and switches clustered. In two switches (in second slots) I have 1000Base-SX. Can I configure Gigabit EtherChannel between this cluster and Cat.6506?

3 REPLIES
New Member
New Member

Re: EtherChannel

I couldn't find any information in the link on doing what the original post asked. I don't think it can be done, but I also have the same question. What he asked was if etherchannel could be split across multiple 3500 series switches that were set up in a cluster.

New Member

Re: EtherChannel

Look at another thread going on in this area about etherchannel on a 3550 for I think you might run into the same problem.

Etherchannel should also work by combining 2 GBIC's in the SAME switch. You cannot use multiple 35xx switches and combine their GBIC's into one channel.

Clustering the switches will only give you the ability of easy management, it does not really do anything more.

135
Views
0
Helpful
3
Replies