I've recently purchased 3 2500 series routers to setup a lab in order to study for the CCNP. My question is that I've assigned an IP and mask to E0 and the only way that I can access this interface is by enabling IP host-routing. When I ran debug all I noticed that packets where getting to the router but the router could not respond back with a "nonroutable" error message generated from the debug. Is there anything that I am missing here?
assuming you did a no shut it sounds like you are not pinging from the same ip network you configured on E0. The router doesnt know where that network is and with no default route cant route the packet.
Yes the interface was brought up with the "no shutdown" command...and when I run debug I can see packets from workstations to the router interface but the responses back from the router get a "unrouteable" error message.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...