My question is that I've assigned an IP and mask to E0 and the only way that I can access this interface is by enabling IP host-routing. When I ran debug all I noticed that packets where getting to the router but the router could not respond back with a "nonroutable" error message generated from the debug. Is there anything that I am missing here? And yes the interface was brought up with the "no shutdown" command.
Please make sure that ip routing is not disabled, . Use ip routing to enable ip routing from global mode and If you are accessing the router from the different network, please put the default route by using ip route 0.0.0.0 0.0.0.0
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.