Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

etherswitch and routing

Hello,

Is it possible for and etherswitch module on a 3745 or 3725 to the fastethernet ports as routers ports ?

Or use vlan from the etherswitch module to make the 37.. between them ?

Best regards

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: etherswitch and routing

No you cannot use them as routed ports

3745-A(config-if)#ip address 10.1.1.1 255.255.255.0

% IP addresses may not be configured on L2 links.

The following page should help as well

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122x/122xt/122xt_2/ft1636nm.htm

1 REPLY
Cisco Employee

Re: etherswitch and routing

No you cannot use them as routed ports

3745-A(config-if)#ip address 10.1.1.1 255.255.255.0

% IP addresses may not be configured on L2 links.

The following page should help as well

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122x/122xt/122xt_2/ft1636nm.htm

109
Views
0
Helpful
1
Replies
CreatePlease to create content