cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
305
Views
0
Helpful
3
Replies

Example config of LLQ between Point to Point T-1

randyclark
Level 1
Level 1

Does anyone have an example config of LLQ on for H323.

I have a 2600 router connecting three 2500 series routers using Ip unnumbered on the serial ports.

2 Accepted Solutions

Accepted Solutions

ciscoblood
Level 1
Level 1

I assume you are running the p-p links, with ppp as encapsulation.

This link does shed light on configuring LLQ on p-p links running ppp

http://www.cisco.com/en/US/tech/tk652/tk701/technologies_tech_note09186a0080094660.shtml#subfirsttwo

View solution in original post

Hi,

VoIPover Serial (leased lines), using HDLC encapsulation, is a practical, easy-to-implement-and-configure choice for T1 link speeds and higher. VoIPovSerial (leased lines), using MLPPP encapsulation, offers fragmentation and interleaving (LFI) to ensure acceptable voice quality on slower link speeds down to 56K.

Depending on the speeds, you might want to choose ppp or HDLC encapsulations.

View solution in original post

3 Replies 3

ciscoblood
Level 1
Level 1

I assume you are running the p-p links, with ppp as encapsulation.

This link does shed light on configuring LLQ on p-p links running ppp

http://www.cisco.com/en/US/tech/tk652/tk701/technologies_tech_note09186a0080094660.shtml#subfirsttwo

It looks like no encapsulation is running on the links. I take it that encapsultion must be used to run LLQ. Below is part of the config.

interface FastEthernet0/0

ip address 192.20.192.1 255.255.255.0

ip broadcast-address 192.20.192.255

no ip directed-broadcast

speed 100

full-duplex

decnet cost 10

bridge-group 1

!

interface Serial0/0

bandwidth 768

ip unnumbered FastEthernet0/0

no ip directed-broadcast

no ip mroute-cache

decnet cost 10

mop enabled

bridge-group 1

bridge-group 1 lat-compression

!

interface Serial0/1

description bandwidth 768

ip unnumbered FastEthernet0/0

no ip directed-broadcast

decnet cost 10

mop enabled

bridge-group 1

bridge-group 1 lat-compression

!

Hi,

VoIPover Serial (leased lines), using HDLC encapsulation, is a practical, easy-to-implement-and-configure choice for T1 link speeds and higher. VoIPovSerial (leased lines), using MLPPP encapsulation, offers fragmentation and interleaving (LFI) to ensure acceptable voice quality on slower link speeds down to 56K.

Depending on the speeds, you might want to choose ppp or HDLC encapsulations.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco