Thank you, I've looked as expect.nist.gov, but I haven't purchased the expect book yet.
Unfortuanely I'm trying to do this function through a set of hands-off scripts, so I don't think the hyperterm option will work out (that is what our Field Engineers use now, but we're trying to protect the system from them!).
If you know the ASCII value of the sequence (30??), you could then use the octal value of that and preface it with a "\". For example, if it is 30, then the octal value would be 36 and you could have send "\036". See http://www.hume.com/html83/mann/Tcl.html for more info.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...