Experiencing error on int fa 0/24

[mchabloz]

Hello,

I hope you can help me , since a week , i've got error on a link .

FastEthernet0/24 is up, line protocol is up

Hardware is Fast Ethernet, address is 0002.b992.de58 (bia 0002.b992.de58)

Description: cogetex

MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,

reliability 255/255, txload 1/255, rxload 2/255

Encapsulation ARPA, loopback not set

Keepalive not set

Full-duplex, 10Mb/s, 100BaseTX/FX

ARP type: ARPA, ARP Timeout 04:00:00

Last input never, output 00:00:00, output hang never

Last clearing of "show interface" counters never

Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 98000 bits/sec, 10 packets/sec

5 minute output rate 17000 bits/sec, 8 packets/sec

215861707 packets input, 961761432 bytes

Received 13450 broadcasts, 0 runts, 0 giants, 0 throttles

1289404 input errors, 628369 CRC, 661035 frame, 4147 overrun, 4147 ignored

0 watchdog, 12 multicast

0 input packets with dribble condition detected

184147571 packets output, 2982421995 bytes, 0 underruns

0 output errors, 0 collisions, 3 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

No change had be done recently .

Thank

Marc

[lgijssel]

You could do the following:

Check the cabling

Check the remote side duplex setting

Try another port on your switch if this does not help. In that way you can detemine if the cause is in the switch or somewhere external.

[prafuljaded]

Check your port speed and duplex settings on the PC/ Server connected to the port. Its better you force speed to 100Mbps and Full duplex if NIC supports it. Do the same on the port.