I try to connect to the LAN switch by following the instructions with DHCP-enabled PC. With any PC, broswer, OpSys when I type the a browser cisco.com the result is an attempt to access http://169.254.0.1/espress-setup.htm which is expected. But "the page is not found" or similar message is reported. An attempt to reset to factory defaults results in message similar to "http://169.254.0.1/reset.htm not found".
Otherwise the switch is usable as an upmanaged "hub". What is wrong?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.