It allows you to set optional parameters when issuing a PING, the same goes for an extended traceroute. If your platform supports it you can issue IPX pings as well as IP. See the output below showing you the various options:
Target IP address: 192.168.255.253
Repeat count : 100
Datagram size :
Timeout in seconds :
Extended commands [n]: y
Source address or interface: loopback0
Type of service : 184
Set DF bit in IP header? [no]:
Validate reply data? [no]:
Data pattern [0xABCD]:
Loose, Strict, Record, Timestamp, Verbose[none]:
Sweep range of sizes [n]:
Type escape sequence to abort.
Sending 100, 100-byte ICMP Echos to 192.168.255.253, timeout is 2 seconds:
Packet sent with a source address of 192.168.255.254
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.