Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
wc
New Member

Fail to get the bridge forward table from the stack member of C2950

I can use the following command to obtain the bridge address table of the stack member 1 (es1) on vlan 100 of a C35XX series switch by using the following command in a Linux machine:

snmpwalk <switch> <community_string@es1@100>

Now, when I upgade the switch to C2950 series, this command is no longer function. Is there any workaround ? The version I used in 12.1(9)EA1

1 REPLY
New Member

Re: Fail to get the bridge forward table from the stack member o

It may be that snmp is not configured or configured correctly on the switch. Look over this link to see if you config matches. http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2950/1219ea1/ol236202.htm

77
Views
0
Helpful
1
Replies
CreatePlease to create content