I was in the process of upgrading my 2950 IOS from 12.1(9) to 12.1(14) but the process failed on reboot. It is now booting to the switch: prompt and getting "unable to stat flash/: permission denied" when the switch tries to load the new IOS. I reset the boot parameter to load off the old image but still getting permission errors. I cant even view the flash dir. How can I regain my perms so I can load the new IOS? I already followed the procedures in the recovery doc's but again I am unable to complete some tasks due to permissions.
You are in ROM MON mode on the switch. You need to run the suggested commands
once you do a flash_init and load_helper you can use the ? to see what commands are available. You will probably need to load an image onto your switch using xmodem before it will boot properly. You might also want to try to reseat your flash module in the switch.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...