Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

failing 1605?

I havea 1605 thats been rebooting on me lately. I've replaced the power supply but once I saw the info from 'show version' I think the router itself might be bad. Note the software force crash.

This router does debugging level logging to a syslog server, w/ nothing out of the ordinary showing up.

Does anyone have any insight to the error? I'm thinking of replacing the stick of ram in the router. If not I'll have to pitch the entire unit? The version of IOS were running on a number of 1605 and it seems to work just fine so I don't know/think a IOS upgrade will do any good - but I'm not adverse to tring.. Suggestions?

Cisco Internetwork Operating System Software

IOS (tm) 1600 Software (C1600-OY-M), Version 12.2(17a), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2003 by cisco Systems, Inc.

Compiled Thu 19-Jun-03 10:11 by pwade

Image text-base: 0x02005000, data-base: 0x026C3F48

ROM: System Bootstrap, Version 11.1(12)XA, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)

ROM: 1600 Software (C1600-RBOOT-R), Version 11.1(12)XA, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)

evac uptime is 3 days, 14 hours, 27 minutes

System returned to ROM by error - software forced crash, PC 0x213043A

System restarted at 03:58:31 CST Wed Mar 24 2004

System image file is "flash:c1600-oy-mz.122-17a.bin"

cisco 1605 (68360) processor (revision C) with 22528K/2048K bytes of memory.

Processor board ID 09179941, with hardware revision 00000000

Bridging software.

X.25 software, Version 3.0.0.

2 Ethernet/IEEE 802.3 interface(s)

1 Serial network interface(s)

WIC T1-DSU

System/IO memory with parity disabled

8192K bytes of DRAM onboard 16384K bytes of DRAM on SIMM

System running from RAM

7K bytes of non-volatile configuration memory.

16384K bytes of processor board PCMCIA flash (Read/Write)

Configuration register is 0x2102

2 REPLIES
VIP Purple

Re: failing 1605?

Hello,

I checked the bug toolkit, there are lots of bugs in your IOS version, but most of them are due to commands executed or functions performed by the router. Can you say if this behaviour occurs randomly, or when you perform a specific operation ?

Also, can you post the output of the command:

show stacks

after a router failure ?

Regards,

Georg

New Member

Re: failing 1605?

I upgraded the version of IOS to 12.2.23 - same problems. Replaced the power supply - worth a go - same result.

I'll have to post the show stacks output sometime later. As we've replaced the router -- we'll need to replace the simm that was in it next.

84
Views
0
Helpful
2
Replies
CreatePlease to create content