Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Fast Etherchannel/Gigabit FEC across 2 different blades in 6500/4500

Can you do a fast etherchannel/gigabit fast etherchannel link to a closet across 2 different blades from the core? This would in effect provide additional redundancy in case one of the blades fails in the core switch. The 4500/6500 would be running IOS (not cat os).

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Fast Etherchannel/Gigabit FEC across 2 different blades in 6

Yes, it is possible to group the ports across two different modules. Check out this link

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a0080160a03.html#1020420

1 REPLY
Bronze

Re: Fast Etherchannel/Gigabit FEC across 2 different blades in 6

Yes, it is possible to group the ports across two different modules. Check out this link

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a0080160a03.html#1020420

293
Views
0
Helpful
1
Replies
CreatePlease to create content