I have 2 switches 2950-24's that currently each have port #'s 23 and 24 configured for port group 1 to effect a Fast Etherchannel between the two. I want to introduce a 3rd switch into the config to increase port density. I also want to connect this 3rd switch to existing config via Fast Etherchannel. I am confused about the numbering of the port group on the third switch. If I connect one of the existing 2 switches via its port 21 and 22, I would configure these ports on that box as port group 2, since port group 1 is defined already. Does the port group on the new 3rd switch need to match the numbering port group 2 to effect the FastEtherchannel, or do I call the port group on the 3rd switch port group 1, since it is the only FastEtherchannel on that switch?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...